Skip to content
Heat pumps are great, because they pump heat around, and we often don’t want heat where it is. Need it somewhere else? Pump it! It’s great. It’s also a bit pricey if you’re buying new, but [Craftsman Chris] over on YouTube realized that the window air conditioning unit he found in a dumpster is, in fact, a heat pump. Normally it’s an air-source heat pump, but with a delightful series of hacks, he gets it automated and hooked into a ground loop in his latest YouTube video.
The heat sink is provided by a bunch of PEX tubing [Chris] buried in his back yard. After experimenting with using the water loop for cooling directly, he realized that pumping heat out of his house into the cold ground would go much better with a heat pump. That’s where the window A/C came in. After cleaning and servicing it, it was time to convert it to dump heat into water rather than outside air. To do that, [Chris] welded up a tank made of scrap metal around the existing heat exchanger. It’s designed for air, sure, but water takes its heat just fine. The nice thing about this is that by keeping the internals of the air conditioner mostly stock, he doesn’t let out any of the tasty, tasty CFCs that may be hiding inside.
Connecting this unit to his thermostat is equally hacky– he takes an old Programmable Logic Controller that looks fit to run a small factory, and hooks it to a single linear actuator to poke the A/C unit’s stock power button. Is it elegant? No. Does it work? Yes. Is it a hack? Indubitably!
We’ve seen window units pressed into whole-house A/C service before, but adding the water loop is a great hack. We saw a window A/C used as a ground-source pump before, too, but that was a Canadian project and so sensibly turned the machine around to provide heating for the maple mansion.
Instagram Engineering
Shopify Engineering
